Weber 900 LP Owner Manual - Page 14
Step 10, Step 11
View all Weber 900 LP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Step 10 Add fuel scale assembly You will need: fuel scale assembly, two 1/4-20 wing nuts and two nylon washers. Slip the bolts on the back of the fuel scale assembly through the two small holes in the tank panel. Make sure indicator rod of fuel scale is on the left side of the wheel frame. Add washers then wing nuts and tighten. Figure 12. Step 11 Install igniter Note - The igniter wires are already attached to the Gas Catcher Ignition Chamber and the igniter. This was done to factory test the ignition system. The igniter lock nut is on the igniter. Insert the top of the igniter up through the large part of the keyhole in the frame brace. Figure 13 (b). Loosen the igniter lock nut and slide the igniter into the small part of the keyhole. Figure 13 (c). Tighten the igniter lock nut. Figure 13. Note - If the igniter works loose, carefully tighten the igniter lock nut with an adjustable wrench or pliers. (a) E E F F View from front left View from front right Figure 12 Frame brace (b) Figure 13 Keyhole in frame brace Igniter lock nut (c) Frame brace Small part of keyhole in frame brace 14