Weider 1120 English Manual - Page 11

14. Route the Arm Cable (54) over a "V"-pulley (46). 14 Attach the "V"-pulley, a Large Cable Trap (50), two Full Finger Guards (41), and an M10 Washer (57) to the Upright (3) with an M10 x 63mm Bolt (75) and an M10 Nylon Locknut (56). Make sure the Cable Trap is oriented to hold the Cable in the groove of the "V"-pulley. 3 56 41 57 46 50 41 75 54 15. Route the Arm Cable (54) under a 90mm Pulley 15 (48). Attach the Pulley and two Half Finger Guards (43) to the Double "U"-Bracket (63) with an M10 x 46mm Bolt (81) and an M10 Nylon Locknut (56). Make sure the Finger Guards are on the outside of the "U"-bracket as shown. 54 48 43 81 56 43 63 16. Route the Arm Cable (54) over a "V"-pulley (46). 16 Attach the "V"-pulley, a Large Cable Trap (50), two Full Finger Guards (41), and an M10 Washer (57) to the Upright (3) with an M10 x 63mm Bolt (75) and an M10 Nylon Locknut (56). Make sure the Cable Trap is oriented to hold the Cable in the groove of the "V"-pulley. 75 41 50 57 46 41 54 3 56 17. Grease an M8 x 22mm Shoulder Bolt (65). Attach 17 the Arm Cable (54) to the indicated Cable Pivot (39) with the Bolt and an M8 Nylon Locknut (58). Grease 54 65 39 58 11