Weider 1120 English Manual - Page 12

18. Locate the Low Cable (53). Route the Cable 18 through the Leg Lever (8) and the Front Leg (7). Attach a 90mm Pulley (48) inside of the Leg Lever (8), over the Low Cable (53), with an M10 x 67mm Bolt (71), two M10 Washers (57), two 12mm Spacers (52), and an M10 Nylon Locknut (56). 19. Attach a 90mm Pulley (48) inside of the Front Leg 19 (7), over the Low Cable (53), with an M10 x 67mm Bolt (71), two M10 Washers (57), two 12mm Spacers (52), and an M10 Nylon Locknut (56). 56 8 52 57 53 48 7 57 52 71 56 52 57 48 7 53 57 52 71 20. Route the Low Cable (53) under a 90mm Pulley 20 (48) and through the Upright (3). Attach the Pulley inside of the upright with an M10 x 67mm Bolt (71), two M10 Washers (57), two 12mm Spacers (52), and an M10 Nylon Locknut (56). 56 52 57 48 53 3 57 52 71 21. Route the Low Cable (53) over a 90mm Pulley 21 (48). Attach the Pulley and two Half Finger Guards (43) to the Double "U"-Bracket (63) with an M10 x 46mm Bolt (81) and an M10 Nylon Locknut (56). Make sure the Finger Guards are on the outside of the "U"-bracket as shown. 56 43 48 63 43 53 81 12