Weider Max By Xp400 English Manual - Page 6
the Bolt and an M10 Nylon Locknut 76.
View all Weider Max By Xp400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
2. Attach a Wheel (31) to the outside of the Base (1) with an M10 x 78mm Bolt (81), three M10 2 Washers (75), and an M10 Nylon Locknut (76). Do not overtighten the Locknut; the Wheel must be able to turn easily. Attach the other Wheel (not shown) in the same manner. 3. Orient the Cross Tube (11) as shown, with the welded tubes at the bottom. Attach the Cross Tube to the Upright (3) with two M10 x 147mm Carriage Bolts (73), two M10 Washers (75), and two M10 Nuts (47). 3 3 23 73 76 75 75 81 31 1 75 47 Welded Tube 11 4. Press the Front Leg Foot (27) onto the bottom of 4 the Front Leg (6). Note that the front of the Front Leg Foot is taller than the back. Attach the Bench Rail (5), with the hook on the bottom, to the Front Leg (6) with four M10 x 25mm Button Screws (87). 87 87 5 Hook 6 Front 27 5. Lubricate an M10 x 103mm Bolt (66) with grease. 5 Attach the Bench Rail (5) to the Upright (3) with 3 the Bolt and an M10 Nylon Locknut (76). Do not overtighten the Locknut; the Bench Rail must be able to pivot easily. 30 Insert the bolt 76 through this hole Tighten the Storage Knob (30) into the Upright (3) 66 and the Bench Rail (5). 5 Grease 6