Weider Pro 4900 English Manual - Page 17

41. Wrap the Leg Lever Cable (70) under a 90mm 41 Pulley (39). Attach the Pulley and two Half Finger Guards (42) to the Right Base (1) with an M10 x 48mm Bolt (101) and an M10 Nylon Locknut 114 (114). Make sure the Finger Guards are orient- ed as shown. 42 42. Wrap the Leg Lever Cable (70) over a 90mm 42 Pulley (39). Attach the Pulley, a Small Cable Trap (48), and two Half Finger Guards (42) at the sec- ond hole from the bottom of the two Pulley Plates (51) with an M10 x 52mm Bolt (102) and an M10 Nylon Locknut (114). Make sure the Cable Trap and Finger Guards are oriented as shown. 43. Wrap the Leg Lever Cable (70) under a 90mm 43 Pulley (39). Attach the Pulley and two Half Finger Guards (42) to the "U"-bracket on the Right Base (1) with an M10 x 48mm Bolt (101) and an M10 Nylon Locknut (114). Make sure the Finger Guards are oriented as shown and are on the outside of the "U"-bracket. 70 1 39 101 42 114 42 48 51 42 39 102 70 42 114 70 39 42 101 44. Wrap the Leg Lever Cable (70) under a 90mm 44 Pulley (39). Attach the Pulley, a Small Cable Trap (48), and two Half Finger Guards (42) to the bracket on the Right Base (1) with an M10 x 52mm Bolt (102) and an M10 Nylon Locknut (114). Make sure the Cable Trap and Finger Guards are oriented as shown and that the bracket is between the Pulley and the Finger Guard next to the Locknut. 45. Route the Leg Lever Cable (70) up through the 45 Right Top Frame (7), over a115mm Pulley (41), and back down through the Top Frame. Attach the Pulley inside the Top Frame with an M10 x 80mm Bolt (111), two M10 Washers (116), two 19mm Spacers (77), and an M10 Nylon Locknut (114). 1 70 42 114 39 42 48 102 1 Bracket 111 77 116 41 7 70 116 77 114 17