Weider Pro 4900 English Manual - Page 23

the Pad Tube. Press two Foam Caps 58 into - parts

Get Weider Pro 4900 PDF manuals and user guides View all Weider Pro 4900 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 23 highlights

67. Slide the Pad Tube (31) through the Right Seat Frame (9). Slide two Small Foam Pads (32) onto the Pad Tube. Press two Foam Caps (58) into the Pad Tubes. Repeat this step with the Leg Lever (11). 67 58 9 32 31 11 32 58 68. Attach the Knee Pad (30) to the Dip Assist (21) 68 with four M6 x 16mm Screws (85). 30 21 85 85 69. Make sure that all parts have been properly tightened. The use of the remaining parts will be explained in ADJUSTMENTS, beginning on the following page. Before using the weight system, pull each cable a few times to make sure that the cables move smoothly over the pulleys. If one of the cables does not move smoothly, find and correct the problem. IMPORTANT: If the cables are not properly installed, they may be damaged when heavy weight is used. See the CABLE DIAGRAMS on pages 26 and 27 of this manual for proper cable routing. If there is any slack in the cables, you will need to remove the slack by tightening the cables. See MAINTENANCE on page 29. 23

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
69. Make sure that all parts have been properly tightened. The use of the remaining parts will be explained in
ADJUSTMENTS, beginning on the following page.
Before using the weight system, pull each cable a few times to make sure that the cables move smoothly
over the pulleys. If one of the cables does not move smoothly, find and correct the problem.
IMPORTANT: If
the cables are not properly installed, they may be damaged when heavy weight is used. See the
CABLE DIAGRAMS on pages 26 and 27 of this manual for proper cable routing. If there is any slack
in the cables, you will need to remove the slack by tightening the cables. See MAINTENANCE on
page 29.
23
67. Slide the Pad Tube (31) through the Right Seat
Frame (9). Slide two Small Foam Pads (32) onto
the Pad Tube. Press two Foam Caps (58) into the
Pad Tubes.
Repeat this step with the Leg Lever (11).
68. Attach the Knee Pad (30) to the Dip Assist (21)
with four M6 x 16mm Screws (85).
67
68
85
85
21
30
58
32
32
58
31
9
11