Weider Pro 525 English Manual - Page 12

TIGHTENING THE CABLES Woven cable, the type of cable used on the weight rack, can stretch slightly when it is first used. If the cables need to be tightened, remove the M10 Nylon Locknut (20) and the M10 x 45mm Bolt (18) from the lower ends of the Pulley Plates (27). Reattach the 3 1/2" Pulley (16) and Cable Trap (26) to the next higher set of holes in the Pulley Plates. Make sure the Cable Trap holds the Low Cable (24) in the groove of the Pulley. Continue to move the Pulley up until the Cable is tight. Do not overtighten the Nylon Locknut. The Pulley must be able to turn freely. ATTACHING WEIGHTS TO THE WEIGHT CARRIAGE To use the Weight Carriage (7), slide the desired amount of weight (not included) onto each side of the weight tube on the Weight Carriage. WARNING: Do not place more than 150 pounds on the Weight Carriage (7). Always place the same amount of weight on each side of the Weight Carriage. To use Olympic weights, press two Weight Adapter Bushings (36) into the ends of each Weight Adapter (35). Slide a Weight Adapter onto each side of the weight tube on the Weight Carriage (7). Insert the two Lock Pins (34) into the weight tube. 27 18 20 26 16 24 34 36 7 35 36 34 35 Weight Tube 12