Weider Pro 9940 English Manual - Page 15
Note: Thread the Jamnut - cable routing
View all Weider Pro 9940 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
31. Remove a Pro Pulley (26) from the bag labeled "PULLEY BAG 2". Identify the Low Pulley Cable (75). It is approximately 143 1/2" long and it has a ball on one end and a loop on the other. Route the end with the loop through the slot in the cable guide on the Butterfly Base (4). Route the Low Pulley Cable (75) under a Pro Pulley (26) as shown. Attach the Pro Pulley and a Cable Trap (25) to the bracket on the Butterfly Base (4) with a 3/8" x 2" Bolt (54) and a 3/8" Nylon Locknut (50). Make sure the Cable Trap is oriented as shown. 31 54 26 25 Cable Guide 75 4 50 32. Wrap the Low Pulley Cable (75) around a 3 1/2" 32 Pulley (24) in the direction shown. Attach the Pulley and a Cable Trap (25) to the indicated hole in the Butterfly Upright (1) with a 3/8" x 4 3/4" Bolt (60) and a 3/8" Nylon Jamnut (63). Note: Thread the Jamnut only two turns onto the Bolt, since you will later attach another Pulley to the Bolt. Make sure the Cable Trap is oriented as shown. 60 1 24 25 63 75 33. Wrap the Low Pulley Cable (75) over a 3 1/2" Pulley 33 (24) in the direction shown. Attach the Pulley and a Cable Trap (25) to the lower hole in the Adjustable Pulley Plates (23) with a 3/8" x 2" Bolt (54) and a 3/8" Nylon Locknut (50). Make sure the Cable Trap is 54 oriented as shown. 23 50 25 24 75 34. Remove the 3/8" Nylon Jamnut (63) from the 34 3/8" x 4 3/4" Bolt (60) inserted into the Butterfly Upright (1) in step 32. Wrap the Low Pulley Cable (75) around a 3 1/2" Pulley (24) in the direction shown. Attach the Pulley and a Cable Trap (25) to the 3/8" x 4 3/4" Bolt (60) with the 3/8" Nylon Jamnut (63). Make sure the Cable Trap is oriented as shown. 15 1 75 25 60 24 63