Weider Pro 9940 English Manual - Page 16
Wrap the Press Cable 72 around a Pro Pulley 26
View all Weider Pro 9940 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
35. Attach the loop on the end of the Low Pulley Cable 35 (75) to the indicated hole in the Small Leg Lever (41) 41 with a 3/8" x 2 3/4" Bolt (46), two 3/8" Flat Washers (48), and a 3/8" Nylon Jamnut (63). 63 48 75 48 46 36. Remove a Pro Pulley (26) from the bag labeled "PULLEY BAG 2". 36 Identify the Press Cable (72). It is approximately 389 1/2" long and it has a ball on one end and a threaded shaft on the other. You will begin by attaching the end 63 with the ball. 48 Wrap the Press Cable (72) around a Pro Pulley (26) in the direction shown. Attach the Pulley to the indicated hole in the Press Top Frame (9) with a 3/8" x 3 1/2" Bolt (56), a 3/8" Flat Washer (48), and a 3/8" Nylon Jamnut (63). Make sure the Cable is between the Pulley and the welded pin on the Press Top 37. Route the threaded end of the Press Cable (72) 37 around the 3 1/2" Pulley (24) that is already mounted on the Top Frame (9). 9 9 26 72 56 Pin 24 38. Wrap the Press Cable (72) around a 3 1/2" Pulley (24) in the direction shown. Attach the Pulley to the indicated hole in the Press Upright (2) with a 3/8" x 3 3/4" Bolt (59), a 3/8" Flat Washer (48) and a 3/8" Nylon Locknut (50). Make sure the Cable Trap is oriented as shown. 38 50 48 16 72 2 25 24 72 59