Weider Pro 9940 English Manual - Page 7

6. Press a 2" Square Inner Cap (28) half way into the top of the Front Leg (20). Press a 2" Square Inner Cap (28) into each end of the Small Leg Lever (41). Attach the Bumper (40) to the indicated hole in the Front Leg (20) with a 1" Tap Screw (80). Lubricate the 3/8" x 3 1/4" Bolt (62). Attach the Small Leg Lever (41) to the bracket on the Front Leg (20) with the Bolt and a 3/8" Nylon Jamnut (63). Do not overtighten the Nylon Jamnut; it must be easy to pivot the Leg Lever. 6 28 41 28 63 40 80 28 62 20 Lubricate 7. Press a 1" Square Inner Cap (98) into the small tube 7 on the Press Upright (2). Place the bracket on the lower end of the Press Upright (2) over the indicated 5/16" x 2 1/2" Carriage Bolts (92) in the Press Base (6). Hand tighten two 5/16" Nylon Locknuts (64) onto the Bolts. Do not tighten the Nylon Locknuts yet. Place the bracket on the lower end of the Support Frame (3) over the indicated 3/8" x 2 1/2" Carriage Bolt (101) and the 3/8" x 4" Carriage Bolt (102) in the Press Base (6). Hand tighten a 3/8" Nylon Jamnut (63) onto the 3/8" x 2 1/2" Carriage Bolt (101). Do not tighten the Nylon Jamnut yet. Note: Do not thread a Jamnut onto the 3/8" x 4" Carriage Bolt (102) yet. Attach the Support Frame (3) to the Press Upright (2) with two 5/16" x 2 1/2" Carriage Bolts (92) and two 5/16" Nylon Locknuts (64). Do not tighten the Nylon Locknuts yet. 92 2 98 64 64 3 63 64 102 6 101 92 8. Press a 2" Square Inner Cap (28) into the Press Top 8 Frame (9). 89 28 Attach the Press Top Frame (9) to the indicated bracket at the top of the Press Upright (2) with two 5/16" x 2 3/4" Bolts (89), a Support Plate with 3 1/2" 93 center holes (93), and two 5/16" Nylon Locknuts (64). 9 2 64 7