Weider Tech 8.5 Bench English Manual - Page 12
Attach the Foot Plate 28 to the Center Upright
View all Weider Tech 8.5 Bench manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
18. Slide a Barbell Adapter (22) onto the Barbell (18). 18 Then, tighten a Barbell End Knob (44) into the Barbell. Attach the other Barbell Adapter (not shown) in the same way. 18 22 19. Remove the Cable Eyelet (104), the M8 Nut (99), and the Cable Stop (103) from the Low Cable (52). Route the Cable through the Foot Plate (28). Attach the Foot Plate (28) to the Center Upright (3) with two M12 x 70mm Patch Bolts (89) and two M12 Washers (93). Slide the Cable Stop (103) onto the Low Cable (52), and tighten the M8 Nut (99) onto the Cable as far as possible. Next, tighten the Cable Eyelet (104) onto the Cable as far as possible, and tighten the Nut against the Cable Eyelet. Then, slide the Cable Stop onto the Cable Eyelet. 19 89 93 3 28 103 104 52 99 44 89 93 20. Orient a Weight Rest (30) as shown, and insert the pin on the Weight Rest into a slot in the Right Upright (2). Then, rotate the Weight Rest to the position shown in the inset drawing and slide it downward as far as possible. Attach a Weight Spotter (29) below the Weight Rest (30) in the same way. Then, attach the other Weight Rest (30) and the other Weight Spotter (29) to the Left Upright (1). 20 Pin 30 2 29 30 30 1 29 12