Weider Tech 8.5 Bench English Manual - Page 7

3. Attach the Front Leg (109) to the Bench Frame 3 (107) with two M10 x 75mm Bolts (105), two M10 Washers (66), and two M10 Nylon Locknuts (65). Make sure that the Nylon Locknuts are in the hexagonal holes in the bottom of the Bench Frame. See step 2. Tighten the M8 Nylon Locknuts (84). 109 105 66 107 65 4. Grease the barrel of an M10 x 70mm Bolt Set (106). Attach the Leg Lever (110) to the Front Leg 4 (109) with the Bolt Set. Make sure that the bar- rel of the Bolt Set is inserted through both sides of the bracket on the Leg Lever. 110 106 Grease 106 109 5. Orient the two Backrest Frames (118) as shown. 5 Attach the Backrest Frames to the Backrest Bracket (111) with four M8 x 45mm Bolts (101), four M8 Washers (102), and four M8 Nylon Locknuts (84). Do not tighten the Nylon Locknuts yet. 118 101 102 Holes 84 102 101 84 111 7