Weslo Flex 3xt English Manual - Page 5

6. Press the Bench Leg Endcap (13) into the end of the Bench Leg (11). Attach the Bench Leg to the Bench Rail (10) with the two Bench Bolts (14), Washers (26) and Nylock Nuts (7). Be sure the Bench Leg is turned so that the hole indicated is opposite the Bench Rail. Wet the insides of two Foam Pads (46) and the ends of a Foam Pad Tube (45) with soapy water. Center the Foam Pad Tube in the Bench Leg (11). Slide the Foam Pads onto the ends of the Tube. Attach the Bench (12) to the Bench Rail (10) with four Bench Screws (8) and Small Washers (9). The narrow end ofihe Bench must be at the same end as the Bench Leg (11). 7. Attach the Bench Rail (10) to the Bottom Upright (2) with the two Bench Rail Bolts (49), Washers (26) and Nylock Nuts (7). 6 12 Hole 26 7-A> 13 14 •• i 10 7 9 26 i i 8 ! 45 8 46 7 e 49 . 10 . . . .. . 7 2 8. Wet the insides of the two Leg Lever Pads (42) and the ends of the foam pad tube on the Leg Lever (40). Slide 8 • the two Leg Lever Pads onto the Leg Lever. Press the two Leg Lever Endcaps (41) into the ends of the Leg Lever (40). Attach the Leg Lever (40) to the Bench Leg (11) with the Leg Lever Pin (43) and Hairpin Cotter Pin (44). 9. Attach the Press Bar (31) to the Press Arm (30) with the two Press Arm Bolts (33), Small Washers (9) and 9 Press Arm Nuts (32). Attach the Press Arm (30) to the Top Upright (1) with a Weightband Tube (28) and two Large Spring Clips (47). The Weightband Tube must be centered in the Upright with the two.Spring'Clipi touching the Press Arm • bracket. . . . _ 43-e, - ,. 42 41 >410, 1-44 40 41 4 11 Foam Pad Tube Press Arm Bracket ,. . • 30 . e • , 1 , I . .; 31 * 9 32 A 5