Weslo Gym 3000 Uk Manual - Page 10

14. Attach a Large "U" Bracket (56) to one of the 14 Arms (46) with a 3/8" x 2 3/4" Bolt (70), 3/8" Flat Washer (9), and 3/8" Nylon Locknut (21). Be sure that the Cable Trap (59) is on the side shown. Attach a Large "U" Bracket (56) to the other Arm (46) in the same manner. 15. Attach the Wide Swivel Bracket (71) to the indicated bracket on the Top Frame (67) with a 5/16" 15 x 3 1/4" Bolt (35) and 5/16" Nylon Locknut (3). Do not overtighten the Nylon Locknut; the Wide Swivel Bracket must be able to swivel freely. 59 21 56 59 21 46 9 56 9 70 70 46 35 67 3 71 16. If the parts shown at the right have not been preassembled, follow the instructions below to assemble them. Attach the two "I" Plates (78) to two 4 1/2" Pulleys (77) with two 3/8" x 1 3/4" Bolts (48) and 3/8" Nylon Locknuts (21) as shown. Do not thread the Nylon Locknuts all the way onto the Bolts until assembly step 24 is completed. 16 77 21 48 78 78 17. IMPORTANT: As you assemble the Long Cable 17 (66) and the Short Cable (not shown), refer to page 19 of this manual to make sure that the Cables are properly routed. Find the end of the Long Cable (66) that does not have a rubber ball. Insert that end of the Long Cable up through the indicated opening in the Top Frame (67). Lay the Long Cable (66) over a 4 1/2" Pulley (77). Attach the Pulley inside the Top Frame (67) with a 3/8" x 2 3/4" Bolt (70), two 3/8" Flat Washers (9), the two 1/2" x 1/2" Spacers (65), and a 3/8" Nylon Locknut (21). 10 66 65 77 65 9 70 21 9 67