Weslo Gym 3000 Uk Manual - Page 5
Assembly
View all Weslo Gym 3000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
ASSEMBLY Make Assembly Easier for Yourself Everything in this manual is designed to ensure that the training system can be assembled successfully by anyone. Before beginning assembly, make sure to read the information on this page; this brief introduction will save you much more time than it takes to read it. Assembly Requires Two Persons For your convenience and safety, assemble the training system with the help of another person. Set Aside Enough Time Due to the many features of the training system, the assembly process will require a few hours. By setting aside plenty of time and by deciding to make the task enjoyable, assembly will go smoothly. You may want to assemble the training system over a couple of evenings. How to Orient Parts As you assemble the training system, make sure that all parts are oriented exactly as shown in the drawings. How to Identify Parts To help you identify the small parts used in assembly, we have included a PART IDENTIFICATION CHART in the center of this manual. Place the chart on the floor and use it to easily identify parts during each assembly step. Note: Some small parts may have been pre-attached. If a part is not in the parts bag, check to see if it has been pre-attached. Make sure you have the following tools: • Two adjustable wrenches • One standard screwdriver • One phillips screwdriver • One rubber mallet • You will also need grease or petroleum jelly, a small amount of soapy water, and clear tape or masking tape. Note: Assembly will be more convenient if you have a socket set, a set of open-end or closed-end wrenches, or a set of ratchet wrenches. How to Unpack the Box Place all parts of the training system in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. Select a Location for the Training System Because of its weight and size, the training system should be assembled in the location where it will be used. Make sure that there is enough room to walk around the training system as you assemble it. Tightening Parts Tighten all parts as you assemble them, unless instructed to do otherwise. Questions? If you have questions after reading the assembly instructions, please call our Customer Service Department at 0345-089009. 1. Before you begin, make sure that you have 1 carefully read the instructions at the top of this page. Press a 2" Inner Cap (27) into the Base (4). Attach the Pulley Plate (20) to the Base (4) with two 5/16" x 2 3/4" Bolts (11), two 5/16" Flat Washers (8), and two 5/16" Nylon Locknuts (3). Insert the two 5/16" x 2 1/2" Carriage Bolts (1) up through the Base (4). 5 20 11 4 38 1 27