Weslo Momentum 7.0 Ex Elliptical English Manual - Page 11

MAINTENANCE AND TROUBLESHOOTING Inspect and tighten all parts of the elliptical exerciser regularly. Replace any worn parts immediately. To clean the elliptical exerciser, use a damp cloth and a small amount of mild soap. Important: Keep liquids away from the console and keep the console out of direct sunlight. During storage, remove the batteries from the console. BATTERY REPLACEMENT If the console display becomes dim, the batteries should be replaced; most console problems are the result of low batteries. To replace the batteries, see step 5 on page 6 and remove the console from the upright. Next, see step 4 on page 6 and insert two batteries into the console. Reattach the console to the upright, being careful not to pinch the wires. HOW TO ADJUST THE REED SWITCH If the console does not display correct feedback, the reed switch should be adjusted. To adjust the reed switch, you must first remove the Left Pedal Arm (11) and the Left Side Shield (3). 42 56 3 40 11 42 35 70 22 42 Remove the Pedal Arm Bolt Set (40), the M10 x 25mm Patch Screw (22), the M10 Washer (35), and the Wave Washer (70) from the Left Pedal Arm (11), and remove the Left Pedal Arm. Next, remove the two M4 x 25mm Screws (56) and the four M4 x 16mm Screws (42) from the Left Side Shield (3), and remove the Left Side Shield. See the drawings below and locate the Reed Switch (53). (Note: For clarity, the left Pedal Disc [15] is not shown.) Loosen, but do not remove, the indicated M4 x 16mm Screw (42). Slide the Reed Switch slightly toward or away from the Magnet (58) on the right Disc Crossbar (16), and then retighten the Screw. Turn the Pedal Discs for a moment. Repeat until the console displays correct feedback. When the Reed Switch is correctly adjusted, reattach the Left Side Shield (3) and the Left Pedal Arm (11). 58 16 53 42 HOW TO ADJUST THE DRIVE BELT If the pedals slip while you are pedaling, even when the resistance is adjusted to the highest setting, the Drive Belt (19) may need to be adjusted. To adjust the Drive Belt, you must first remove the left side shield. See HOW TO ADJUST THE REED SWITCH at the left and remove the left side shield. Next, loosen the M8 x 22mm Flat Head Screw (41) and turn the Idler Adjustment Bolt (62) until 19 the Drive Belt 41 (19) is tight. When the Drive Belt is tight, tighten the Flat 62 Head Screw. Reattach the left side shield and the left pedal arm. 11