Weslo Momentum 7.0 Ex Elliptical English Manual - Page 5

ASSEMBLY To hire an authorized service technician to assemble the elliptical exerciser, call toll-free 1-800-445-2480. Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. In addition to the included allen wrenches, assembly requires a Phillips screwdriver , an adjustable wrench , and a rubber mallet . Use the drawings below to identify the small parts used for assembly. The number in parenthesis below each drawing is the key number of the part, from the PART LIST on page 14. The number following the key number is the quantity needed for assembly. Note: Some small parts may have been pre-assembled. If a part is not in the parts bag, check to see if it has been pre-assembled. M6 Nylon M10 Nylon M8 Split M10 Split Wave Washer M10 Locknut (27)-4 Locknut (33)-6 Washer (69)-2 Washer (59)-2 (70)-2 Washer (35)-2 M6 x 36mm Button Bolt (50)-4 M6 x 48mm Flat Head Screw (36)-4 M8 x 16mm Button M10 x 25mm Screw (68)-2 Patch Screw (22)-2 M10 x 68mm Button Bolt (48)-2 M10 x 70mm Carriage Bolt (34)-4 Pedal Arm Bolt Set (40)-2 1. Identify the Front Stabilizer (10), which is narrower than the Rear Stabilizer (not shown). While another person lifts the front of the Frame (1), attach the Front Stabilizer to the Frame with two M10 x 70mm Carriage Bolts (34) and two M10 Nylon Locknuts (33). 1 34 10 5 1 33