Weslo Momentum G 3.2 Elliptical English Manual - Page 11

11. The Console (23) can use four AA batteries (not included); alkaline batteries are recommended. 11 Do not use old and new batteries together or alkaline, standard, and rechargeable batter- ies together. IMPORTANT: If the Console has been exposed to cold temperatures, allow it to warm to room temperature before insert- ing batteries. Otherwise, you may damage the console or other electronic components. Remove the battery cover from the back of the Console (23), and insert batteries into the battery compartment. Make sure to orient the batteries as shown by the diagram inside the battery compartment. Then, reattach the battery cover. 12. While a second person holds the Console (23) near the Upright (2), connect the wires on the 12 Console to the Wire Harness (31), to the Pulse Wires (A), and to the Ground Wire (102). Insert the excess wire into the Console (23) or into the Upright (2). Tip: Avoid pinching the wires. Attach the Console (23) to the Upright (2) with four M4 x 12mm Screws (66). See step 4. Tighten the M8 x 20mm Screws (54) and the M8 Locknuts (53). 23 Battery Compartment 23 Avoid pinching the wires A 102 31 2 66 13. Attach the Seat (69) to the Seat Carriage (61) with three M8 Locknuts (53) and three M8 13 Washers (55). Note: The Locknuts and Washers may be preattached to the Seat. 69 61 55 53 11