Weslo Momentum G 3.2 Elliptical English Manual - Page 19
Maintenance And Troubleshooting
View all Weslo Momentum G 3.2 Elliptical manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
MAINTENANCE AND TROUBLESHOOTING Inspect and tighten all parts of the hybrid trainer regularly. Replace any worn parts immediately. To clean the hybrid trainer, use a damp cloth and a small amount of mild soap. IMPORTANT: To avoid damage to the console, keep liquids away from the console and keep the console out of direct sunlight. Next, carefully pull the Right Shield (4) outward and upward until you can reach the Idler Adjustment Bolt (34). CONSOLE TROUBLESHOOTING If the console display becomes dim, replace all the batteries at the same time; most console problems are the result of low batteries. See assembly step 11 on page 11 for replacement instructions. If the console does not display your heart rate when you use the handgrip heart rate monitor, see step 4 on page 16. HOW TO ADJUST THE DRIVE BELT If you can feel the pedals slip while you are pedaling, even when the resistance is adjusted to the highest level, the drive belt may need to be adjusted. To adjust the drive belt, first remove the seven indicated M4 x 20mm Screws (68). 4 7 34 70 19 Next, loosen the M10 Nut (70), and turn the Idler Adjustment Bolt (34) counterclockwise until the Drive Belt (19) is tight. Then, retighten the Nut. See the drawing at the left. Reattach the Right Shield (4) with the seven M4 x 20mm Screws (68). 4 68 68 68 68 19