Weslo Vector 502 Uk Manual - Page 5

ASSEMBLY Assembly requires two persons. Place all parts of the exercise cycle in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. Assembly requires the included tools and your own adjustable spanner driver , and pliers . , Phillips screw- Use the part drawings below to identify the small parts used in assembly. The number in parenthesis below each drawing refers to the key number of the part, from the PART LIST on page 18. The second number refers to the quantity needed for assembly. Note: Some small parts may have been pre-attached for shipping. If a part is not in the parts bag, check to see if it has been pre-attached. Ground Screw (27)-1 M8 Nylon Locknut (10)-3 3/8" Nylon Locknut (33)-4 M8 Flat Washer (51)-3 M5 x 12mm Screw (49)-4 3/8" x 114mm Carriage Bolt (30)-4 1. Orient the Front Stabiliser (2) so that the Wheels (23) are on the side shown. Whilst another person lifts the front of the Frame (1) slightly, attach the Front Stabiliser with two 3/8" x 114mm Carriage Bolts (30) and two 3/8" Nylon Locknuts (33). Make sure that the Front Stabiliser is turned so the Wheels are not touching the floor. 1 30 23 2. Whilst another person lifts the rear of the Frame (1) slightly, attach the Rear Stabiliser (6) with two 3/8" x 2 114mm Carriage Bolts (30) and two 3/8" Nylon Locknuts (33). 23 2 33 1 33 6 33 1 30 5