Weslo Vector 502 Uk Manual - Page 7

6. Whilst another person holds the Upright (13) in the position shown, connect the console wire to the Reed Switch Wire (43). Next, connect the console cable to the Lower Cable (45) in the following way: • Refer to inset drawing A. Pull up on the metal bracket (MB) on the Lower Cable (45), and insert the tip of the console cable (CC) into the wire clip inside of the metal bracket. • Refer to inset drawing B. Firmly pull the console cable (CC) and slide it into the metal bracket on the Lower Cable (45) as shown. • Refer to inset drawing C. Using pliers, squeeze the prongs on the upper end of the metal bracket together. Carefully push the excess wire and cable down into the Frame (1), and insert the Upright (13) into the Frame. Be careful to avoid pinching the wires and cables. Next, align one of the adjustment holes in the Upright with the indicated hole in the Frame. Insert the Adjustment Knob (9) into the Frame and the Upright, and turn the Knob clockwise until it is tight. Make sure that the Knob is inserted through one of the adjustment holes in the Upright. 6 13 Console Cable 45 Be careful to avoid pinching the wires. Adjustment Holes Console Wire 43 Hole 9 1 A MB B MB C 7. Attach the Seat (12) to the Seat Bracket (50) with three M8 Nylon Locknuts (10) and three M8 Flat Washers (51). Note: The Nylon Locknuts and Flat Washers may be preattached to the underside of the Seat. Orient the Seat (12) and the Seat Post (5) as shown. Insert the pin on the bottom of the Seat Bracket (50) into the indicated slot on the Seat Post. Tighten the Seat Knob (36) into the Seat Bracket. CC 45 7 51 10 Pin CC MB 45 12 50 51 10 Slot 36 5 7