Whirlpool DP840SWSX Use and Care Guide - Page 14

Cycle Selection Charts For Series 840: Press the desired cycle. Turn the cycle control knob to the desired cycle. If the door is latched, you will hear the cycles start and stop as the cycle control knob passes each cycle mark. This is normal and does not hurt the dishwasher. If you prefer, you can set the cycle control knob with the door unlatched. NOTE: Heavy Wash, Normal Wash and Rinse Only all share the same cycle button. For Series 860: Press the desired cycle. Turn the cycle control knob to the desired cycle. If the door is latched, you will hear the cycles start and stop as the cycle control knob passes each cycle mark. This is normal and does not hurt the dishwasher. If you prefer, you can set the cycle control knob with the door unlatched. To use Rinse Only, press HEAVY WASH or NORMAL WASH and turn the cycle control knob to Rinse Only. A "q" shows what steps are in each cycle. Water usage is shown in U.S. gallons/liters. Cycle time includes dry time. Pots & Pans Use this cycle for hard-to-clean, heavily soiled pots, pans, casseroles, and regular tableware. Use both detergent dispenser sections. Wash Rinse Rinse Main Rinse Final Dry Time Water Wash Rinse (min) Usage (gal/L) q q q q q q q 98 8.6/32.7 Heavy Wash Use this cycle for loads with with heavy food soil. Use both detergent dispenser sections. Wash Rinse Rinse Main Rinse Final Dry Time Water Wash Rinse (min) Usage (gal/L) q q q q q q 90 7.2/27.2 Normal Wash Use this cycle for loads with normal amounts of food soil. (The energy-usage label is based on this cycle.) Use both detergent dispenser sections. Wash Rinse Rinse Main Rinse Final Dry Time Water Wash Rinse (min) Usage (gal/L) q q q q q 85 5.7/21.8 Rinse Only Use this cycle for rinsing dishes, glasses, and silverware that will not be washed right away. Do not use detergent with this cycle. Wash Rinse Rinse Main Rinse Final Dry Time Water Wash Rinse (min) Usage (gal/L) q q 20 2.9/10.9 Canceling a Cycle You can cancel a cycle at any time. 1. Turn the cycle control knob slowly clockwise until you hear water draining. Let the dishwasher drain completely. 2. Open the door. 3. Turn the cycle control knob to Off. Changing a Cycle or Setting You can change a cycle anytime during a cycle. 1. Lift the door latch to stop the cycle. 2. Turn the cycle control knob clockwise. 3. Check the detergent dispensers. They must be filled properly for the new cycle. NOTE: Turning the cycle control knob can cause the covered detergent dispenser section to open and release the detergent. Check the covered section if the cycle uses detergent in both sections. 4. Close the door firmly until it latches. The dishwasher starts a new cycle. 14