Whirlpool KGSK901SSS Installation Instructions - Page 16
Whirlpool KGSK901SSS Manual
View all Whirlpool KGSK901SSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
GAS CONVERSIONS Gas conversions from Natural gas to LP gas or from LP gas to Natural gas must be done by a qualified installer. WARNING 3. Remove warming drawer or storage drawer. See the "Remove Warming or Storage Drawer" section for instructions. Locate gas pressure regulator at rear of storage or warming drawer compartment. NOTE: On models with a warming drawer, an access cover must be removed from the gas pressure regulator. A Explosion Hazard Use a new CSA International approved gas supply line. Install a shut-off valve. Securely tighten all gas connections. If connected to LP, have a qualified person make sure gas pressure does not exceed 14" (36 cm) water column. Examples of a qualified person include: licensed heating personnel, authorized gas company personnel, and authorized service personnel. Failure to do so can result in death, explosion, or fire. A. Gas pressure regulator IMPORTANT: Do not remove the gas pressure regulator. Gas pressure regulator 4. Remove plastic cover from gas pressure regulator cap. 5. Turn gas pressure regulator cap (marked "N" on front of gas pressure regulator) counterclockwise with a wrench to remove. NOTE: Do not remove the spring beneath the cap. Side view before LP Gas Conversion A N WARNING B D E Tip Over Hazard A child or adult can tip the range and be killed. Connect anti-tip bracket to rear range foot. Reconnect the anti-tip bracket, if the range is moved. Failure to follow these instructions can result in death or serious burns to children and adults. C Side view after A. Plastic cover B. Gas pressure regulator cap with solid end facing out C. Gas pressure regulator cap with hollow end facing out D. Washer E. Gas pressure regulator cap To Convert Gas Pressure Regulator 1. Turn manual shutoff valve to the "closed" position. 2. Unplug range or disconnect power. 6. Turn the gas pressure regulator cap over and reinstall on regulator so that the hollow end faces out and letters "LP" are visible. 7. Replace plastic cover over gas pressure regulator cap. B A C A. To range B. Manual shutoff valve "closed" position C. Gas supply line 16