Whirlpool MEDE200XW Installation Instructions - Page 10
Connect neutral wire, Connect remaining wires, Remove center screw, Connect ground wire
View all Whirlpool MEDE200XW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
9. Connect ground wire 11. Remove center screw F B A Connect ground wire (F) (green or bare) of power supply cord to external ground conductor screw (A). Tighten screw. 10. Connect remaining wires Remove center, silver-colored terminal block screw (B). 12. Connect neutral wire C B Connect remaining wires to outer terminal block screws. Tighten screws. Finally, reinsert tab of terminal block cover into slot of dryer rear panel. Secure cover with hold-down screw. Now, go to Venting Requirements. 3-wire Power supply cord Connection Use where local codes permit connecting cabinet-ground conductor to neutral wire. B D E A C GF A. 3-wire receptacle (NEMA type 10-30R) B. 3-wire plug C. Neutral prong D. Spade terminals with upturned ends E. 3/4" (19 mm) UL listed strain relief F. Ring terminals G. Neutral (white or center wire) Connect neutral wire (white or center wire) (C) of power supply cord to center, silver-colored terminal block screw (B). Tighten screw. 13. Connect remaining wires Connect remaining wires to outer terminal block screws. Tighten screws. Finally, reinsert tab of terminal block cover into slot of dryer rear panel. Secure cover with hold-down screw. Now, go to Venting Requirements. 10