Whirlpool MEDE200XW Installation Instructions - Page 5
Installation spacing for recessed area or closet, installation, Closet installation dryer only,
View all Whirlpool MEDE200XW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
Back view: 61/4" (159 mm) Closet installation (dryer only): Electric 34" recommended (864 mm) 18" min. (457 mm) 3" (76 mm) 48 in.2 (310 cm2) 283/4" (733 mm) 33/4" (83 mm) 4" (102 mm) 3" (76 mm) 24 in.2 (155 cm2) 1" (25 mm) 1" (25 mm) 13" (330 mm) Cabinet installation (dryer only): NOTE: Most installations require a minimum of 5" (127 mm) clearance behind dryer for exhaust vent with elbow. See "Venting Requirements." IMPORTANT: Do not operate, install, or store dryer where it will be exposed to water, weather, or at temperatures below 45° F (7° C). Lower temperatures may cause dryer not to shut off at end of automatic sensor cycles, resulting in longer drying times. Installation spacing for recessed area or closet installation All dimensions show recommended spacing allowed, with tested spacing of 0" (0 mm) clearance on sides and rear. ■■ Additional spacing should be considered for ease of installation and servicing. ■■ Additional clearances might be required for wall, door, and floor moldings. ■■ Additional spacing should be considered on all sides of the dryer to reduce noise transfer. ■■ For closet installation, with a door, minimum ventilation openings in the top and bottom of the door are required. Louvered doors with equivalent ventilitation openings are acceptable. ■■ Companion appliance spacing should also be considered. 7" (178 mm) 18" (460 mm) 4" (102 mm) 1" (25 mm) 1" (25 mm) 5