Whirlpool MEDE200XW Installation Instructions - Page 18
Level Dryer, Connect Vent
View all Whirlpool MEDE200XW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
38. Turn on cold water faucet 41. Move dryer to final location Check that the water faucets are turned on. 39. Check for leaks Check for leaks around "Y" connector, faucet, and hoses. Connect vent 40. Connect vent to exhaust outlet Move dryer to final location, taking care not to crush or kink vent. After dryer is in place, remove corner posts and cardboard from under dryer. Level dryer 42. Level Dryer Place level here Check levelness of dryer from side to side. Repeat from front to back. NOTE: The dryer must be level for the moisture sensing system to operate correctly. Using a 4" (102 mm) clamp, connect vent to exhaust outlet in dryer. If connecting to existing vent, make sure vent is clean. Dryer vent must fit over dryer exhaust outlet and inside exhaust hood. Check that vent is secured to exhaust hood with a 4" (102 mm) clamp. Not Level LEVEL Not Level 18