Whirlpool RBD245PDT Use and Care Guide - Page 17

Single oven 22-3/8" max. recessed width 23"max. recessed 23-3/4" _overallwidth Double oven 22-3/8" max. J J 29" max. overall height 49-1/2" recessed height 51" max. overall height 23"max. recessed depth J 23-3/4" width •_-- 24"min. ---_- cabinet width 27-3/4" min. cutout height 22-1/2" cutout width _1 Single oven undercounter (without cooktop installed above) + l-1/2"min. top ofcutout to underside of countertop 49-3/4" min. cutout height + 1-1/2" min. bottom of cutout to top of cabinet door 5-1/4" bottom of cutout to floor 24" min. _--- cabinet width -- 24" min. cabinet _-_ 1"top ofcutout to bottom of upper cabinet door J_ 7- 22-1/2" cutout -width 14-3/4" bottom of cutout to floor Double oven T 27-3/4" min. cutout height 22-1/2" •_--- cutout ---_- width 1" top of cutout to bottom of upper cabinet door •_-_--- 23-1/4"min. cutoutdepth 23"recessed oven depth + 1-1/2" min. bottom of cutout to top of cabinet door Single oven 32" bottom of cutout to floor cabinet---+-- recessed oven oven / front Cabinet side view Page 1 Important: Observe all governing codes and ordinances. Proper installation isyour responsibility. Have a qualified technician install this oven. Oven location should be away from strong draft areas, such as windows, doors and strong heating vents. Cabinet opening dimensions that are shown must be used. Given dimensions provide minimum clearance. Recessedinstallation area must provide complete enclosure around the recessed portion of the oven. Electrical ground is required. See "Electrical requirements." Electrical supply junction box should be located 3 inches maximum below the support surface when oven is installed in a wall cabinet. Drill a 1-inch minimum diameter hole in the right rear or left rear corner of the support surface to pass the appliance cable through to the junction box. For undercounter installation, it is recommended that the junction box be located in the adjacent right or left cabinet. If installing the junction box on rear wall behind oven, junction box must be recessed and located in the upper or lower right or left corner of cabinet. Oven support surface MUST be solid, level and flush with bottom of cabinet cutout. It is the customer's responsibility: To contact a qualified electrical installer. To assure that the electrical installation is adequate and in conformance with National Electrical Code, ANSI/NFPA 70 -- latest edition*, and all local codes and ordinances. Copies of the standards listed may be obtained from: * National Fire Protection Association Batterymarch Park Quincy, Massachusetts 02269 Tool needed: Z screwdriver Parts supplied: 4 screws (double oven) Note: If installing a single oven, you will need only two screws and two door removal pins.