Whirlpool RBD245PDT Use and Care Guide - Page 6

ELECTRONICOVENCONTROL 1 2 3 l i i 4 56 _ Ii 7 8 9 10 1. Upper Oven Temperature Display 2. Electronic Display 3. Lower Oven Temperature Display 4. Timer 5. Clock 6. Oven Light 7. Oven Selector 8. Oven Settings 9. Temperature Setting 10. Timed Cooking 11 12 13 14 11. Hour 12. Minute 13. Start/Enter [Control Lock] 14. Off/Cancel When power is first supplied to the appliance, everything on the display will light up for 5 seconds. Then, the time of day and "PF" will appear on the electronic oven display. Any other time "PF" appears, a power failure occurred. To reset the clock, press UPPER OFF or LOWER OFF on double oven models. On single oven models, press OFF/CANCEL. Electronic Display When the oven(s)are in use, this display shows the oven temperature. On double oven models, this display will also show which oven is being set. The left cavity symbol represents the upper oven and the right cavity symbol represents the lower oven. If "Err" appears on the oven display, an invalid pad was pressed. Press UPPER OFF or LOWER OFF and retry entry. On single oven models, press OFF/CANCEL. When the ovens are not in use, the display will show the time of day. Start/l ter The START/ENTER pad begins any oven function except the Timer. If not pressed within 5 seconds after pressing a pad, "START?" will appear on the oven display as a reminder. If not pressed within 5 minutes after pressing a pad, the oven display will return to the time of day mode and the programmed function will be cancelled. Upper Lower Offer Oil]Cancel The UPPER OFF, LOWER OFF and OFF/CANCEL pads stop their respective oven functions except for the Clock, Timer and Control Lock. The cooling fan may continue to operate even after an oven function has been cancelled, depending on the oven temperature. Clock This is a 12 hour clock and does not show a.m. or p.m. To Set: Before setting, make sure the ovens, Timer and Timed Cooking are off. 1. Press CLOCK. 2. Press the HR or MIN "up" or "down" arrow pads to set the time of day. 3. Press CLOCK or START/ENTER. To remove the time of day from the display: Press and hold CLOCK for 5 seconds. To return the time of day to the display: Press CLOCK. The time should not have to be reset. Tones Tones are audible signals, indicating the following: One tone • Valid pad press • Oven is preheated • Function has been entered Three tones • Invalid pad press Four tones • End-of-cycle • Reminder, repeating each minute after the end-of-cycle tones All Tones All of the above tones are preset on, but can be turned off. To Turn Off/On: Press and hold STOP TIME for 5 seconds, and a tone will sound. On double ovens only, "Snd oFF" will appear on the oven display for 3 seconds. Repeat to change back to "Snd on".