Xerox 6180N DocuSP Getting Started - Page 34
Performing a recovery
UPC - 095205425307
View all Xerox 6180N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 34 highlights
DOCUSP 4.1 30 Performing a recovery Performing a recovery may require one or two steps: ♦ If the system disk had to be replaced, a flash (clean) install of Solaris must first be performed. This partitions the system disk and takes approximately 20-25 minutes. A Solaris install must be performed by the Xerox service representative. As soon as the system starts rebooting, halt to the system at the ok prompt by pressing [Stop][A]. ♦ Launch the recovery program by following the steps below. 1. The system must be booted to single-user mode from CDROM. If the TGBackup scripts are on CD, the CD must be bootable to perform the recovery. 2. Ensure that the tape drive is connected, powered on and that the tape cassette #1 is inserted in the drive. If multiple tape drives are attached to the system, make sure the others are offline or have no tapes in them. The program attempts to use the first ready tape drive it finds. 3. Insert a bootable CD/DVD (Solaris flash install CD or bootable TGBackup CD). 4. Power the system on. When the message boot device file and args appears, press [Stop][A] to bring the system to the ok prompt. NOTE: For some controllers, it may be necessary to substitute cdromide for cdrom in the next step. Refer to your documentation for the correct terminology for your specific controller. 5. Enter the command boot cdrom -s to boot into singleuser mode. The system may take up to 5 minutes to display the # prompt. 6. Enter the command /etc/init.d/volmgt start to start the volume manager. 7. Enter the command cd /cdrom/cdrom0/TGBackup to change the directory to the location of the recovery files. 8. Enter the command sh start_tgrestore to launch the recovery. The program searches for a tape drive and begin the recovery process. NOTE: If the backup spanned multiple cassettes, the system prompts the user to insert the next volume when all the data is read from the current tape. 9. Upon completion the program reboots the printer. XEROX DOCUMENT SERVICES PLATFORM SERIES GETTING STARTED