Yamaha DM1000 Owner's Manual - Page 245
Turn on the CONTROL CHANGE Tx ON/OFF and Rx ON/OFF buttons.
View all Yamaha DM1000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 245 highlights
Assigning Parameters to Control Changes for Real-time Control 245 If you wish to control Delay Time parameters on certain channels using Control Changes, you must assign the same channel Delay parameter to three Control Change numbers, and select "TIME LOW," "TIME MID," and "TIME HIGH" for the Control Changes in the parameter boxes in the second (middle) PARAMETER column. Note: Parameters that feature a setting range in excess of 128 steps require an appropriate combination of range parameters for successful MIDI Control Change. Tip: You can initialize the Parameter to Control Change assignment table by moving the cursor to the INITIALIZE button, then pressing [ENTER]. 7 Press the DISPLAY ACCESS [MIDI] button repeatedly until the MIDI | Setup page appears, then specify MIDI Transmit and Receive Channels. 8 Turn on the CONTROL CHANGE Tx ON/OFF and Rx ON/OFF buttons. DM1000 parameters will now be set accordingly when the DM1000 receives corresponding Control Changes. Also, when you adjust parameters on the DM1000, the DM1000 will transmit corresponding Control Changes. Note: Before controlling parameters using Control Changes, make sure that both Tx and Rx ON/OFF buttons in the PARAMETER CHANGE row are turned off. 18 DM1000-Owner's Manual MIDI