Yamaha LS9-32 Dme-n Network Driver Installation Guide For Ls9 - Page 12

Troubleshooting (FAQ) When controlling the LS9 from your computer via Ethernet, the LS9 does not operate correctly. • Is the Ethernet cable connected correctly? Refer to the "Connection of computer and the LS9" section. • Is the DME-N Network Driver set up appropriately? Refer to the "Setup" section. • Did you enter an appropriate IP address of the LS9? Set the IP address of the LS9 in the MISC SETUP screen of the LS9. If you are connecting the LS9 to your computer in a one-to-one connection, we recommend that you make the following initial settings. IP address 192.168.0.128 Gateway address 192.168.0.1 Subnet mask 255.255.255.0 However, it must not conflict with the IP address of any other device on the network. For details on settings when connecting to a LAN, refer to the LS9 Editor installation guide. • Is the computer network setup appropriately? Confirm the network setup by following the procedures in the "TCP/IP Settings" section. If you are connecting the LS9 to your computer in a one-to-one connection, we recommend that you make the following settings. IP address 192.168.0.3 Subnet mask 255.255.255.0 Default gateway 192.168.0.1 However, it must not conflict with the IP address of any other device on the network. For details on settings when connecting to a LAN, refer to the LS9 Editor installation guide. • Are the settings of the LS9 and peripheral network devices (including switching hubs) appropriate? Refer to the relevant owner's manuals for the LS9 and peripheral network devices (including switching hubs) for details. • Have you selected an appropriate ports in the LS9 Editor and Studio Manager? Select the LS9 as the input/output port settings of LS9 Editor and Studio Manager. • Are you using the latest DME-N Network Driver? The latest driver can be downloaded from the Yamaha website http://www.yamahaproaudio.com/ • Are the settings of your security software appropriate? If using Windows firewall: For Windows XP Click [Start] → [Control Panel] → [Windows Firewall] → [General] tab. Remove the [Don't allow exceptions] checkbox. For Windows Vista Click [Start] → [Control Panel] → [Windows Firewall] → [Change settings] → [General] tab. Remove the [Block all incoming connections] checkbox. For Windows 7 Click [Start] → [Control Panel] → [Windows Firewall]. Confirm the communication with the DME-N Network Driver is permitted at [Inbound Rules] and [Monitoring] → [Firewall]. If using other security software: Either set the security software to allow use of TCP port 12300 on the network card being used by the DME-N Network Driver, or disable the security software. DME-N Network Driver Installation Guide for LS9 U.R.G., Pro Audio & Digital Musical Instrument Division, Yamaha Corporation 12 © 2006 Yamaha Corporation C0