Yamaha MO6 Owner's Manual - Page 143

Internal Structure (System Overview) ● In the Performance mode The Effect parameters in the Performance mode are set for each Performance. [PERFORM] → Performance selection → [EDIT] → [COMMON] → [F6] EFFECT → [SF1] CONNECT System effects (Reverb effect and Chorus effect) Chorus Ctg, Chorus Typ (Chorus Effect Category, Chorus Effect Type) Reverb Typ (Reverb Effect Type) Determines the effect type for Chorus. Chorus Send, Reverb Send Determines the level of the sound (from Insertion A or B, or the bypassed signal) that is sent to Chorus/Reverb effect. These parameters can be set in the Performance in the [F2] OUT/MEF display (*3). Settings: 0 - 127 Chorus Return, Reverb Return Chorus Pan, Reverb Pan Determines the Return level and pan position setting for the Chorus/Reverb effect. Settings: 0 - 127, L63 (far left) - C (center) - R63 (far right) Chorus to Reverb Determines the Send level of the signal sent from the Chorus Effect to the Reverb Effect. Settings: 0 ~ 127 The Insertion connection type depends on the setting of the Voice assigned to the selected Part. Tone Generator block *1 Part 1 Part EQ *2 Part 1 Insertion Effect (VCE INS) A B *3 Reverb Send Chorus Send Reverb Return Chorus Return Master effect *4 Master EQ [PERFORM] → Performance selection → [EDIT] → [COMMON] → [F2] OUT/MEF → [SF3] MEF Output *1 Select the part to which the Insertion effect is applied. The Insertion effect depends on the setting of the Voice assigned to the selected part. [PERFORM] → Performance selection → [EDIT] → [COMMON] → [F6] EFFECT → [SF2] INS SW *2 [PERFORM] → Performance selection → [EDIT] → Part selection → [F3] EQ *3 [PERFORM] → Performance selection → [EDIT] → [COMMON] → [F2] OUT/MEF → [SF1] OUT *4 [PERFORM] → Performance selection → [EDIT] → [COMMON] → [F2] OUT/MEF → [SF2] MEQ [PERFORM] → Performance selection → [EDIT] → [COMMON] → [F1] GENERAL → [SF3] MEQ OFS Basic Structure Owner's Manual 143