Yamaha RX-V359 Owner's Manual - Page 22
Connecting the FM and AM antennas
View all Yamaha RX-V359 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
CONNECTIONS Connecting the FM and AM antennas Both FM and AM indoor antennas are supplied with this unit. In general, these antennas should provide sufficient signal strength. Connect each antenna correctly to the designated terminals. ■ Connecting the AM loop antenna 1 Set up the AM loop antenna. Notes • The AM loop antenna should be placed away from this unit. • A properly installed outdoor antenna provides clearer reception than an indoor one. If you experience poor reception quality, install an outdoor antenna. Consult the nearest authorized YAMAHA dealer or service center about outdoor antennas. • The AM loop antenna should always be connected, even if an outdoor AM antenna is connected to this unit. Outdoor AM antenna Use a 5 to 10 m (16 to 32 ft) of vinyl-covered wire extended outdoors from a window. AM loop Indoor FM antenna antenna (supplied) (supplied) 2 Press down the tab of the AM ANT terminal. TUNER AM ANT GND FM ANT 3 Insert the one of the AM loop antenna lead wires into the AM ANT terminal. 4 Release the tab back to secure the wire. Ground For maximum safety and minimum interference, connect the antenna GND terminal to a good earth ground. A good earth ground is a metal stake driven into moist earth. 5 Repeat steps 2 through 4 to connect the other lead wire to the GND terminal. Once you have properly connected the AM loop antenna to this unit, orient the AM loop antenna for the best reception when you tune into AM stations. 18