ZyXEL ZyWALL USG 300 User Guide - Page 894

Chapter 52 File Manager These files have the same syntax, which is also identical to the way you run CLI commands manually. An example is shown below. Figure 586 Configuration File / Shell Script: Example # enter configuration mode configure terminal # change administrator password username admin password 4321 user-type admin # configure ge3 interface ge3 ip address 172.23.37.240 255.255.255.0 ip gateway 172.23.37.254 metric 1 exit # create address objects for remote management / to-ZyWALL firewall rules # use the address group in case we want to open up remote management later address-object TW_SUBNET 172.23.37.0/24 object-group address TW_TEAM address-object TW_SUBNET exit # enable Telnet access (not enabled by default, unlike other services) ip telnet server # open WAN-to-ZyWALL firewall for TW_TEAM for remote management firewall WAN ZyWALL insert 4 sourceip TW_TEAM service TELNET action allow exit write While configuration files and shell scripts have the same syntax, the ZyWALL applies configuration files differently than it runs shell scripts. This is explained below. Table 260 Configuration Files and Shell Scripts in the ZyWALL Configuration Files (.conf) Shell Scripts (.zysh) • Resets to default configuration. • Goes into CLI Privilege mode. • Goes into CLI Configuration mode. • Runs the commands in the shell script. • Runs the commands in the configuration file. You have to run the example in Figure 586 on page 894 as a shell script because the first command is run in Privilege mode. If you remove the first command, you have to run the example as a configuration file because the rest of the commands are executed in Configuration mode. Comments in Configuration Files or Shell Scripts In a configuration file or shell script, use "#" or "!" as the first character of a command line to have the ZyWALL treat the line as a comment. 894 ZyWALL USG 300 User's Guide