eMachines EL1358G eMachines EL1358 Service Guide - Page 73
Jumper Setting, Jumper, Description, Setting default
View all eMachines EL1358G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 73 highlights
Jumper Setting This section explains how to set the jumper for correct configuration of the main board. Jumpers with more than one pin are numbered. When setting a jumper, ensure that the jumper caps are placed on the correct pins. The following illustration shows the location of JBIOS1. The following table shows the settings of the 3-pin Clear CMOS (JBIOS1) jumper. Place the jumper cap on pins 1 and 2 to close or short the jumper. Place the jumper cap on pins 2 and 3 to open or clear the jumper. Jumper JBIOS1 Type 3-pin Description Clear CMOS Setting (default) 1-2: Close (default) 2-3: Open Before clearing the CMOS, make sure to turn off the system. EL1358 Service Guide 65
EL1358 Service Guide
65
Jumper Setting
This section explains how to set the jumper for correct configuration of the main board.
Jumpers with more than one pin are numbered. When setting a jumper, ensure that the jumper caps are
placed on the correct pins.
The following illustration shows the location of JBIOS1.
The following table shows the settings of the 3-pin Clear CMOS (JBIOS1) jumper. Place the jumper cap on
pins 1 and 2 to close or short the jumper. Place the jumper cap on pins 2 and 3 to open or clear the jumper.
Jumper
Type
Description
Setting (default)
JBIOS1
3-pin
Clear CMOS
1-2: Close (default)
2-3: Open
Before clearing the CMOS,
make sure to turn off the
system.