eMachines T3958 User Guide - Page 58

Replacing the system battery - bios

Get eMachines T3958 PDF manuals and user guides View all eMachines T3958 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 58 highlights

Chapter 5: Maintaining Your Computer Replacing the system battery If the computer clock does not keep time or the settings in the BIOS Setup utility are not saved when you turn off your computer, replace the system battery. Use a battery of the same size and voltage as the original battery that was in your computer. Warning Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type recommended by the manufacturer. Dispose of used batteries following the manufacturer's instructions. To replace the battery: 1 Restart your computer. 2 During the restart, press and hold the F1 key. The main menu of the BIOS Setup utility opens. 3 Write down all the values in the menus and submenus, then exit from the utility. 4 Shut down your computer. 5 Remove the side panel by following the instructions in "Removing the side panel" on page 46. 6 For more stability, place your computer on its side. To avoid scratching the case, place it on a towel or other non-abrasive surface. 7 Locate the old battery on the system board and note its orientation. You will need to install the new battery the same way. Important Your computer's battery location may vary from the illustration below. 8 Push the battery release tab. The battery pops out of the socket. 52 www.eMachines.com

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
52
www.eMachines.com
Chapter 5: Maintaining Your Computer
Replacing the system battery
If the computer clock does not keep time or the settings in the BIOS Setup utility are
not saved when you turn off your computer, replace the system battery. Use a battery
of the same size and voltage as the original battery that was in your computer.
To replace the battery:
1
Restart your computer.
2
During the restart, press and hold the
F1
key. The main menu of the BIOS Setup utility
opens.
3
Write down all the values in the menus and submenus, then exit from the utility.
4
Shut down your computer.
5
Remove the side panel by following the instructions in
“Removing the side panel”
on page 46
.
6
For more stability, place your computer on its side. To avoid scratching the case, place
it on a towel or other non-abrasive surface.
7
Locate the old battery on the system board and note its orientation. You will need
to install the new battery the same way.
8
Push the battery release tab. The battery pops out of the socket.
Warning
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type recommended by the
manufacturer. Dispose of used batteries following the manufacturer
’
s
instructions.
Important
Your computer’s battery location may vary from the illustration below.