2012 Acura RDX Owner's Manual - Page 186

Playing the XM® Radio (Models without navigation system) Operating the XM Radio To listen to the XM Radio, turn the ignition switch to the ACCESSORY (I) or ON (II) position. Push the PWR/VOL knob to turn on the audio system, and press the button. Adjust the volume by turning the PWR/VOL knob. The last channel you listened to will show on the audio display. DISP － Each time you press and release the DISP/MODE button, the center display changes in the following sequence: Channel name, category, artist name, and music title. MODE － To switch between the category mode and channel mode, press and hold the DISP/MODE button until the mode changes. A ''CH'' (channel) or ''CAT'' (category) mode indicator appears on the center display. To Select a Channel When in the satellite radio mode, you can use any of four methods to find channels: TUNE, SEEK/SKIP (CATEGORY), SCAN, and the preset bars. TUNE － Press the TUNE/FOLDER bar to change channel selections. Press the side of the bar to tune to higher numbered channels, and the side of the bar to tune to lower numbered channels. In the category mode, you can only select channels within that category. SEEK/SKIP (CATEGORY) － Press either side of the SEEK/SKIP (CATEGORY) bar ( or ) to select another category. SCAN － The scan function gives you a sampling of all channels while in the channel mode. In the category mode, only the channels within that category are scanned. To activate scan, press the SCAN button. The system plays each channel in numerical order for a few seconds, then selects the next channel. When you hear a channel you want to continue listening to, press the button again. 180