2009 BMW M3 Owner's Manual - Page 88
2009 BMW M3 Manual
Page 88 highlights
Technology for driving comfort and safety One wheel yellow There is a flat tire or substantial loss of tire pressure in the indicated tire. A message appears on the Control Display. reset is completed during your drive, and can be interrupted at any time. When driving resumes, the reset is continued automatically. The indicator lamp goes out after the system reset is completed. All wheels yellow There is a flat tire or substantial loss of tire pressure in several tires. A message appears on the Control Display. Via iDrive iDrive, for operating principle refer to page 16. 1. "Vehicle Info" 2. "Vehicle status" 3. "Reset TPM" Gray The system cannot detect a puncture. Possible reasons for this: > TPM is being reset > Temporary malfunction caused by systems or devices using the same radio frequency > Malfunction Resetting the system Each time a tire inflation pressure has been corrected or a wheel or tire has been changed, reset the system.< 4. Start the engine - do not drive away. 5. Start the initialization using "Reset TPM". 6. Start to drive. The tires are shown in gray and "Resetting TPM..." is displayed. After driving a few minutes, the set inflation pressures in the tires are accepted as the target values to be monitored. The system reset is completed during your drive, and can be interrupted at any time. When driving resumes, the reset is continued automatically. On the Control Display, the tires are shown in green and "Status: TPM active" is displayed again. If a flat tire is detected while the system is resetting and determining the inflation pressures, all wheels on the Control Display are displayed in yellow. The message "Tire low!" is shown.< Using the button in the center console 1. Start the engine, but do not start driving. 2. Press the button for approx. 4 seconds until the warning lamp in the instrument cluster lights up yellow. Warning lamp, refer to Message for low tire inflation pressure on page 86. The message "Resetting TPM..." appears on the Control Display for several seconds. Message for low tire inflation pressure 3. Start to drive. After driving a few minutes, the set inflation pressures in the tires are accepted as the target values to be monitored. The system 86 Online Edition for Part no. 01 41 2 600 999 - © 08/08 BMW AG The warning lamps come on in yellow and red. A message appears on the Control Display. In addition, a signal sounds. There is a flat tire or substantial loss of tire pressure.