2000 Chevrolet Impala Owner's Manual - Page 82
2000 Chevrolet Impala Manual
Page 82 highlights
yellowblue FOB PROG (Remote Keyless Entry Transmitter Programming): This feature allows you to match the remote keyless entry transmitter to your vehicle. To match the transmitter: 1. Scroll, using the SEEK up or down arrows, until FOB PROG appears on the display. 2. Press the PREV or NEXT button to enter the submenu. The current selection will have an asterisk next to it. BEGIN will be displayed. 3. Press the DISP button to start programming. When the message PUSH FOB flashes, press and hold the LOCK and UNLOCK buttons on the first transmitter at the same time for 15 seconds. A chime will be heard to verify the transmitter is learned. 4. Repeat Step 3 for each additional transmitter. EXIT (Exit Feature Customization Mode): This feature allows you to exit the vehicle customization programming. To exit: PasslockR Your vehicle is equipped with the Passlock theft-deterrent system. Passlock is a passive theft-deterrent system. Passlock enables fuel if the ignition lock cylinder is turned with a valid key. If a correct key is not used or the ignition lock cylinder is tampered with, fuel is disabled. During normal operation, the SECURITY message will go off approximately five seconds after the key is turned to the ON ignition position. If the engine stalls and the SECURITY message flashes, wait until the light stops flashing before trying to restart the engine. Remember to release the key from START as soon as the engine starts. If the engine is running and the SECURITY message comes on, you will be able to restart the engine if you turn the engine off. However, your Passlock system is not working properly and must be serviced by your dealer. Your vehicle is not protected by Passlock at this time. You may also want to check the fuse (see "Fuses and Circuit Breakers" in the Index). See your dealer for service. In an emergency, call the Chevrolet Roadside Assistance Center at 1-800-CHEV-USAR (1-800-243-8872). (In Canada, call 1-800-268-6800.) D Scroll until EXIT appears on the display. D Press the DISP button to exit programming. A chime will be heard to verify the exit. 2-19