2003 Chevrolet Corvette Owner's Manual - Page 266

Brakes Brake Fluid The other reason is that fluid is leaking out of the brake system. If it is, you should have your brake system fixed, since a leak means that sooner or later your brakes won't work well, or won't work at all. So, it isn't a good idea to "top off' your brake fluid. Adding brake fluid won't correct a leak. If you add fluid when your linings are worn, then you'll have too much fluid when you get new brake linings. You should add (or remove) brake fluid, as necessary, only when work is done on the brake hydraulic system. i Your brake master cylinder reservoir is on the driver's side of the engine compartment. It is filled with UWT-3 brake iiuia. See Engine Gompanmenr zlverview on page 5-12. There are only two reasons why the brake fluid level in the reservoir might go down. The first is that the brake fluid goes down to an acceptable level during normal brake ini in^ ' A ' P = I Y . Wher! new !inings are put in, Y the fluid level goes back up. If you have too mu -.'akc _ _ 1, itcan spill on the engine. The fluid will burn if the engine is hot enough. You or others could be burned, and your vehicle could be damaged. Add brake fluid only when work is done on the brake hydraulic system. See "Checking Brake Fluid" in this section. Refer to the Maintenance Schedule to determine when to check your brake fluid. See Part C: Periodic !vMik17ance i17specihs 017 page 6- i 1. 5-37