2011 Chevrolet Aveo Owner's Manual - Page 116

5-4 Instruments and Controls Clear ice and snow from the wiper blades before using them. If frozen to the windshield, carefully loosen or thaw them. Damaged wiper blades should be replaced. See Wiper Blade Replacement on page 10‑30. Heavy snow or ice can overload the wipers. A circuit breaker stops them until the motor cools. The spray continues until the lever is released. The wipers will run a few times and either stop or will resume at the speed being used previously. See Washer Fluid on page 10‑24 for information on filling the windshield washer fluid. INT (Intermittent): Move to this position for a delayed wiping cycle. Turn the band on the windshield wiper toward FAST or SLOW for a shorter or longer delay between wipes. The wiper speed can only be adjusted when the lever is in the INT position. OFF: Turns the windshield wipers off. Misting Function Move the lever toward INT for a single wiping cycle. Hold it there until the windshield wipers start; then let go. The windshield wipers will stop after one wipe. If more wipes are needed, hold the band toward INT longer. { WARNING In freezing weather, do not use your washer until the windshield is warmed. Otherwise the washer fluid can form ice on the windshield, blocking your vision. Windshield Washer To use this feature, the ignition must be turned to ON/RUN. Pull the windshield washer/wiper lever toward you to spray washer fluid on the windshield.