2011 Chevrolet Express 1500 Cargo Owner's Manual - Page 150

5-32 Units Instruments and Controls See Tire Pressure on page 10‑60 and Tire Messages on page 5‑40 for more information. If the tire pressure display shows dashes instead of a value, there may be a problem with the vehicle. If this consistently occurs, see your dealer for service. Engine Hours Press T until ENGINE HOURS displays. This display shows the total number of hours the engine has run. Relearn Tire Positions The vehicle may have this display. To access this display, the vehicle must be in P (Park). If the vehicle has the Tire Pressure Monitor System (TPMS), after rotating the tires or after replacing a tire or sensor, the system must re-learn the tire positions. To re-learn the tire positions, see Tire Pressure Monitor System on page 10‑62. See Tire Inspection on page 10‑66, Tire Rotation on page 5‑40 and Tire Messages on page 5‑40 for more information. Change Compass Zone The vehicle may have this feature. To change the compass zone through the DIC, see Compass on page 5‑5. Calibrate Compass The vehicle may have this feature. The compass can be manually calibrated. To calibrate the compass through the DIC, see Compass on page 5‑5. Blank Display This display shows no information. Press T until UNITS displays. This display allows you to select between metric or English units of measurement. Once in this display, press V to select between METRIC or ENGLISH units. Tire Pressure If the vehicle has the Tire Pressure Monitor System (TPMS), the pressure for each tire can be viewed in the DIC. The tire pressure will be shown in either kilopascals (kPa) or pounds per square inch (psi). Press T until the DIC displays FRONT TIRES PSI (kPa) LEFT ## RIGHT ##. Press T again until the DIC displays REAR TIRES PSI (kPa) LEFT ## RIGHT ##. If a low tire pressure condition is detected by the system while driving, a message advising you to check the pressure in a specific tire will appear in the display.