2010 Chrysler Sebring Owner Manual - Page 17
2010 Chrysler Sebring Manual
Page 17 highlights
16 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE All of the keys provided with your vehicle have been authorized dealer or by using the Customer Key Proprogrammed to the vehicle electronics. gramming procedure. This procedure consists of programming a blank key to the vehicle electronics. A blank Replacement Keys key is one which has never been programmed. NOTE: Only keys that have been programmed to the NOTE: When having the Sentry Key Immobilizer vehicle electronics can be used to start the vehicle. Once System serviced, bring all vehicle keys with you to the a Sentry Key has been programmed to a vehicle, it authorized dealer. cannot be programmed to any other vehicle. Customer Key Programming CAUTION! You can program new keys to the system if you have two valid Sentry Keys by performing the following proceAlways remove the Sentry Key from the vehicle and dure: lock all doors when leaving the vehicle unattended. 1. Cut the additional Sentry Key Transponder blank(s) At the time of purchase, the original owner is provided to match the ignition switch lock cylinder key code. with a four-digit Personal Identification Number (PIN). 2. Insert the first valid key into the ignition switch. Turn The PIN is required for authorized dealer replacement of the ignition switch to the ON position for at least three keys. Duplication of keys may be performed at an seconds, but no longer than 15 seconds. Then, turn the ignition switch to the LOCK position and remove the first key.