2010 Chrysler Sebring Owner Manual - Page 18
2010 Chrysler Sebring Manual
Page 18 highlights
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 17 3. Insert the second valid key into the ignition switch. Turn the ignition switch to the ON position within 15 seconds. After ten seconds, a chime will sound. In addition, the Vehicle Security Light will begin to flash. Turn the ignition switch to the LOCK position and remove the second key. Repeat this procedure to program up to eight keys. If you do not have a programmed Sentry Key contact your authorized dealer for details. NOTE: If a programmed key is lost, see your authorized dealer to have all remaining keys erased from the systems memory. This will prevent the lost key from starting 4. Insert a blank Sentry Key into the ignition switch. your vehicle. The remaining keys must then be reproTurn the ignition switch to the ON position within grammed. All vehicle keys must be taken to your autho60 seconds. After 10 seconds, a single chime will sound. rized dealer at the time of service to be reprogrammed. In addition, the Vehicle Security Light will stop flashing. General Information To indicate that programming is complete, the indicator The Sentry Key system complies with FCC rules part 15 light will turn on again for three seconds and then turn and with RSS-210 of Industry Canada. Operation is off. subject to the following conditions: The new Sentry Key is programmed. The Remote • This device may not cause harmful interference. Keyless Entry (RKE) transmitter will also be pro• This device must accept any interference that may be grammed during this procedure. received, including interference that may cause undesired operation. 2