2013 Chrysler Town & Country Owner's Manual - Page 115

THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 113 Any seat belt system will loosen with time, so check the Installing Child Restraints Using The Top Tether belt occasionally, and pull it tight if necessary. Anchorage - Second Row Captains Chairs If the buckle or the cinching latch plate is too close to the 1. Look behind the seating position where you plan to install the child restraint to find the tether anchorage. belt path opening of the child restraint, you may have You may need to move the seat forward to provide trouble tightening the seat belt. If this happens, disconbetter access to the tether anchorage. If there is no top nect the latch plate from the buckle and twist the short tether anchorage for that seating position (see the buckle-end belt up to three full turns to shorten it. Insert charts above), move the child restraint to another the latch plate into the buckle with the release button position in the vehicle if one is available. facing out, away from the child restraint. Repeat steps 4 to 6, above, to complete the installation of the child 2. Route the tether strap to provide the most direct path restraint. for the strap between the anchor and the child seat. If your vehicle is equipped with adjustable rear head If the belt still cannot be tightened after you shorten the restraints, raise the head restraint, and where possible, buckle, disconnect the latch plate from the buckle, turn route the tether strap under the head restraint and the buckle around one half turn, and insert the latch plate between the two posts. If not possible, lower the head into the buckle again. If you still cannot make the child restraint and pass the tether strap around the outboard restraint installation tight, try a different seating position. side of the head restraint. 2