2013 Chrysler Town & Country Owner's Manual - Page 265

UNDERSTANDING THE FEATURES OF YOUR VEHICLE 263 • To program the two remaining HomeLink௡ buttons, Canadian/Gate Operator Programming repeat each step for each remaining button. DO NOT For programming transmitters in Canada/United States erase the channels. that require the transmitter signals to "time-out" after several seconds of transmission. Reprogramming A Single HomeLinkா Button To reprogram a channel that has been previously trained, Canadian radio frequency laws require transmitter signals to time-out (or quit) after several seconds of transfollow these steps: mission - which may not be long enough for HomeLink௡ 1. Turn the ignition switch to the ON/RUN position. to pick up the signal during programming. Similar to this 2. Press and hold the desired HomeLink௡ button until Canadian law, some U.S. gate operators are designed to the indicator light begins to flash after 20 seconds. Do time-out in the same manner. not release the button. It may be helpful to unplug the device during the cycling 3. Without releasing the button proceed with "Program- process to prevent possible overheating of the garage ming A Rolling Code" Step 2 and follow all remaining door or gate motor. steps. 1. Cycle the ignition to the ON/RUN position. 3