2013 Chrysler Town & Country Owner's Manual - Page 34

32 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE • The engine can be started times (two 15 minutes cycles) with the RKE transmitter. However, the ignition switch must be cycled by pushing the START/ STOP button twice (or the ignition switch must be cycled to the ON/RUN position). To Enter The Vehicle After Remote Start equipped). Then, prior to the end of the 15-minute cycle, press and release the START/STOP button. If the START/STOP button is not present, insert the Key Fob into the ignition switch and turn the switch to the ON/RUN position. NOTE: To enter the vehicle while the engine is running during a • For vehicles equipped with the Electronic Vehicle Remote Start, you must first unlock the vehicle using the Information Center (EVIC), the message "Insert Key/ UNLOCK button on the RKE transmitter. After the Turn to ON" will flash in the EVIC until you insert the vehicle is unlocked, you can enter the vehicle, press and Key Fob. Once inserted, the message "Remote Start release the START/STOP button (or insert the Key Fob Active - Key To RunЉ will display in the EVIC until you into the ignition switch and move it to the ON/RUN insert and turn the key to the ON/RUN position. position), otherwise the engine will shut off at the end of • For vehicles not equipped with the Keyless Enter-N15- minute cycle. Go™ feature, the ignition switch must be in the To Exit Remote Start Mode And Drive The Vehicle ON/RUN position in order to drive the vehicle. Before the end of the 15-minute cycle, press and release • For vehicles not equipped with the Keyless Enter-Nthe UNLOCK button on the RKE transmitter to unlock Go™ feature, the message "Remote Start Active - Key the doors and disarm the Vehicle Security Alarm (if