2008 Dodge Viper Owner Manual - Page 183
2008 Dodge Viper Manual
Page 183 highlights
182 WHAT TO DO IN EMERGENCIES (B) Setting Up to Use TIREFIT: Turn the Mode Select knob (4) to the Sealant/ Air Mode position. (C) Injecting TIREFIT Sealant into the deflated tire: 1. Always start the engine before turning on the TIREFIT kit. 2. After pressing the Air Pump Power Button (3), the air pump should start to inflate the tire and the sealant (white fluid) will flow from the Sealant Bottle (1) through the Sealant Hose (7) and into the tire. NOTE: Some sealant may leak out through the puncture in the tire. 3. If the sealant Does Not Flow Through the Clear Sealant Hose (7): • Press the Air Pump Power Button (3) to turn off the TIREFIT kit. Disconnect the Clear Sealant Hose (7) from the valve stem. Make sure the valve stem is free of debris. Reconnect the Clear Sealant Hose (7) to the valve stem. Press the Air Pump Power Button (3) to turn on the TIREFIT kit. 1. Uncoil the Clear Sealant Hose (7) and then remove the Yellow Cap from the fitting at the end of the hose. 2. Place the TIREFIT kit flat on the ground next to the deflated tire. 3. Remove the cap from the valve stem and then screw the fitting at the end of the Sealant Hose (7) onto the valve stem. 4. Uncoil the Power Plug and Cable (5) and then insert the plug into the vehicle's power outlet. NOTE: Do not remove foreign objects (e.g., screws or nails) from the tire.