2010 Dodge Dakota Extended Cab Owner Manual - Page 151
2010 Dodge Dakota Extended Cab Manual
Page 151 highlights
150 UNDERSTANDING THE FEATURES OF YOUR VEHICLE Your vehicle should be parked outside of the garage If the signal is too weak to train, replace the battery in the while training. handheld transmitter. NOTE: Some gate operators and garage door openers may require you to replace Step 3 with procedures noted 2. Place the handheld transmitter 1 to 3 inches (3 to 8 cm) in the "Gate Operator/Canadian Programming" section. from the HomeLink buttons while keeping the 4. Press and hold the just-trained HomeLink button. If HomeLink display in view. the indicator(s) blink rapidly for two seconds and then For optimal training, point the battery end of the handremains constant, continue with the next section: "Proheld transmitter away from the HomeLink. gramming A Rolling Code System". 3. Simultaneously, press and hold both the chosen NOTE: After training a HomeLink channel, if the HomeLinkbutton and the handheld transmitter button garage door does not operate with HomeLink and the until the indicator(s) change from a slow to a rapid flash garage door opener was manufactured after 1995, the rate. garage door opener may have rolling code. If so, proceed Then release both the HomeLink and handheld trans- to the heading, "Programming A Rolling Code System." mitter buttons. 5. PROGRAMMING A ROLLING CODE SYSTEM It may take up to 30 seconds or longer in rare cases. The At the garage door opener motor (in the garage), locate garage door may open and close while you train. the "Learn" or "Training" button. 1. Turn the ignition switch to the ON/RUN position.