2011 Dodge Journey Owner Manual - Page 227
2011 Dodge Journey Manual
Page 227 highlights
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 225 successfully accepted the frequency signal. The indica- Reprogramming A Single HomeLinkா Button tor light will flash slowly and then rapidly when fully To reprogram a channel that has been previously trained, follow these steps: trained. If you unplugged the device for training, plug it back in 1. Turn the ignition switch to the ON/RUN position. at this time. 2. Press and hold the desired HomeLink button until Then proceed with Step 4 under "Programming the indicator light begins to flash after 20 seconds. Do not release the button. HomeLink" earlier in this section. Using HomeLinkா To operate, press and release the programmed HomeLink button. Activation will now occur for the trained device (i.e., garage door opener, gate operator, Security system, entry door lock, home/office lighting, etc.,). The handheld transmitter of the device may also be used at any time. 3. Without releasing the button, proceed with Programming HomeLink Step 2 and follow all remaining steps. Security It is advised to erase all channels before you sell or turn in your vehicle. To do this, press and hold the two outside buttons for 20 seconds until the red indicator flashes. Note that all channels will be erased. Individual channels cannot be erased. 3